The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for ups power
- ups Input True Power
- upsInputTruePower 1.3.6.1.4.1.52.4.1.1.10.4.3.1.5 (defined in rfc1628)
The magnitude of the present input true power. - ups Output Power
- upsOutputPower 1.3.6.1.4.1.52.4.1.1.10.5.4.1.4 (defined in rfc1628)
The present output true power. - ups Bypass Power
- upsBypassPower 1.3.6.1.2.1.33.1.5.3.1.4 (defined in rfc1628)
The present true power conveyed by the bypass. - ups Alarm Awaiting Power
- upsAlarmAwaitingPower 1.3.6.1.2.1.33.1.6.3.21 (defined in rfc1628)
The UPS output is off and the UPS is awaiting the return of input power. - ups Config Output Power
- upsConfigOutputPower 1.3.6.1.2.1.33.1.9.6 (defined in rfc1628)
The magnitude of the nominal true power rating. - Compaq Storage System Power Supply Ups Status
- cpqSsPowerSupplyUpsStatus 1.3.6.1.4.1.232.8.2.2.3.1.5 (defined in CPQSTSYS)
Compaq Storage System Power Supply Uninterruptible Power Supply (UPS) Status. The following values are defined: other(1) The agent is unable to determine if this power supply is attached to an Uninterruptible Power Supply (UPS). noUps(2) No UPS is attached to the power supply. ok(3) A UPS is attached to the power supply and is operating normally. powerFailed(4) A UPS is attached to the power supply and the AC power has failed. batteryLow(5) A UPS is attached to the power supply, the AC power has failed and the UPS battery is low. - ups Output Power
- upsOutputPower 1.3.6.1.4.1.52.4.1.1.10.5.4.1.4 (defined in ups2-mib)
The UPS's output load represented as a percentage of full rated load in Watts. The value of this object is the actual percentage * 10 (that is, to determine the actual percentage, divide the value of this object by 10). - ups Addl Funcs Output Apparent Power
- upsAddlFuncsOutputApparentPower 1.3.6.1.4.1.52.4.1.1.10.9.1.1.4 (defined in ups2-mib)
The UPS's output load represented as a percentage of full rated load in Volt-Amps. The value of this object is the actual percentage * 10 (that is, to determine the actual percentage, divide the value of this object by 10). - ups Adv Control Simulate Power Fail
- upsAdvControlSimulatePowerFail 1.3.6.1.4.1.318.1.1.1.6.2.4 (defined in PowerNet-MIB)
Setting this variable to simulatePowerFailure(2) causes the UPS switch to battery power. Setting this value to noSimulatePowerFailure(1) has no effect. The value noSimulatePowerFailure(1) will always be returned when the variable is read.
