The objects described here can be monitored with the IPHost Network Monitor.
You can start SNMP monitoring using free 30-day trial version of IPHost right now.
OID list for token ring port
- Sys Slot Token Ring Port Count
- a3ComSysSlotTokenRingPortCount 1.3.6.1.4.1.43.29.4.2.2.1.11 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The count of TokenRing ports in the slot identified by this entry. - Sys Token Ring Port Count
- a3ComSysTokenRingPortCount 1.3.6.1.4.1.43.29.4.13.1 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The count of token ring ports managed by this agent. - Sys Token Ring Port Table
- a3ComSysTokenRingPortTable 1.3.6.1.4.1.43.29.4.13.2 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
A list of token ring port entries. A single entry exists in this list for each token ring port managed by this agent. - Sys Token Ring Port Internal Errors
- a3ComSysTokenRingPortInternalErrors 1.3.6.1.4.1.43.29.4.13.2.1.12 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
This counter is incremented when a station recognizes an internal error. - Sys Token Ring Port Lost Frame Errors
- a3ComSysTokenRingPortLostFrameErrors 1.3.6.1.4.1.43.29.4.13.2.1.13 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
This counter is incremented when a station is transmitting and its TRR timer expires. This condition denotes a condition where a transmitting station in strip mode does not receive the trailer of the frame before the TRR timer goes off. - Sys Token Ring Port Hard Errors
- a3ComSysTokenRingPortHardErrors 1.3.6.1.4.1.43.29.4.13.2.1.18 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The number of times this interface has detected an immediately recoverable fatal error. It denotes the number of times this interface is either transmitting or receiving beacon MAC frames. - Sys Token Ring Port Ring Status
- a3ComSysTokenRingPortRingStatus 1.3.6.1.4.1.43.29.4.13.2.1.24 (defined in A3COM-SWITCHING-SYSTEMS-MIB)
The current interface status which can be used to diagnose fluctuating problems that can occur on token rings, after a station has successfully been added to the ring. Before an open is completed, this object has the value for the 'no status' condition. This object is useful for debugging problems when the station can not even enter the ring. The object's value is a sum of values, one for each currently applicable condition. The following values are defined for various conditions: 0 = No Problems detected 32 = Ring Recovery 64 = Single Station 256 = Remove Received 512 = reserved 1024 = Auto-Removal Error 2048 = Lobe Wire Fault 4096 = Transmit Beacon 8192 = Soft Error 16384 = Hard Error 32768 = Signal Loss 131072 = no status, open not completed. - a3 Com Sys Token Ring Port Insert Status
- a3ComSysTokenRingPortInsertStatus 1.3.6.1.4.1.43.29.4.13.2.1.4 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
The current value of the link status for the token ring port identified by this entry. - a3 Com Sys Token Ring Port Type
- a3ComSysTokenRingPortType 1.3.6.1.4.1.43.29.4.13.2.1.5 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
Specific port type description for the token ring port identified by this entry. - a3 Com Sys Token Ring Port Speed
- a3ComSysTokenRingPortSpeed 1.3.6.1.4.1.43.29.4.13.2.1.7 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
The current speed of the port. The default speed is sixteenMegabit. - a3 Com Sys Token Ring Port Abort Trans Errors
- a3ComSysTokenRingPortAbortTransErrors 1.3.6.1.4.1.43.29.4.13.2.1.11 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
This counter is incremented when a station transmits an abort delimiter while transmitting. - a3 Com Sys Token Ring Port Frame Copied Errors
- a3ComSysTokenRingPortFrameCopiedErrors 1.3.6.1.4.1.43.29.4.13.2.1.15 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
This counter is incremented when a station recognizes a frame addressed to its specific address and detects that the FS field A bits are set to 1 indicating a possible line hit or duplicate address. - a3 Com Sys Token Ring Port Lobe Wires
- a3ComSysTokenRingPortLobeWires 1.3.6.1.4.1.43.29.4.13.2.1.20 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
The number of times the interface has detected an open or short circuit in the lobe data path. The adapter will be closed when this condition occurs. - a3 Com Sys Token Ring Port Removes
- a3ComSysTokenRingPortRemoves 1.3.6.1.4.1.43.29.4.13.2.1.21 (defined in A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB)
The number of times the interface has received a Remove Ring Station MAC frame request. When this frame is received the interface will enter the close state. - IBM APPN Node Port Token Ring Name
- ibmappnNodePortTrName 1.3.6.1.4.1.2.6.2.13.1.4.4.1.1 (defined in rfc1593)
Administratively-assigned name for this APPN port. The name can be from one to eight characters. - IBM APPN Node Port Token Ring Mac
- ibmappnNodePortTrMac 1.3.6.1.4.1.2.6.2.13.1.4.4.1.2 (defined in rfc1593)
Local Token Ring MAC address. - IBM APPN Node Port Token Ring Sap
- ibmappnNodePortTrSap 1.3.6.1.4.1.2.6.2.13.1.4.4.1.3 (defined in rfc1593)
Local Token Ring Sap address. - Cabletron Bridge Sdb Token Ring IO Receive Port
- ctBridgeSdbTrIORcvPort 1.3.6.1.4.1.52.4.1.2.3.6.4.1.2 (defined in ctron-bridge-mib)
Either the value '0', or the port number of the port from which a frame must be received in order for this entry's filtering information to apply. A value of '0' indicates that this entry applies on all ports of the bridge for which there is no other applicable entry. - Token Ring Management Ring Port Count
- tRingMgmtRingPortCount 1.3.6.1.4.1.52.4.1.2.1.1.1.1.1.3 (defined in dot5-log-mib)
Returns the total number of ring in/out ports on this ring which may be controlled by this device. - Token Ring Management Bcn Rec Ring Port Retry Count
- tRingMgmtBcnRecRingPortRetryCount 1.3.6.1.4.1.52.4.1.2.1.1.1.1.1.14 (defined in dot5-log-mib)
This object defines the number of times a token ring ring port will be re-enabled after it has been determined that the port is causing the ring to beacon. Values other than 0-100 and 999 will result in MIB bad value. Default of object is product dependent. Refer to individual product documentation. Valid integer values are defined as: 0 ...disable ring port retries 1 - 100 ...retry ring port n times 999 ... retry ring port infinite times - Token Ring Port Group Table
- tRingPortGrpTable 1.3.6.1.4.1.52.4.1.2.1.1.2.1 (defined in dot5-log-mib)
A list of port group management objects which pertains to a collection of port groups making up this ring. - Token Ring Port Group Entry
- tRingPortGrpEntry 1.3.6.1.4.1.52.4.1.2.1.1.2.1.1 (defined in dot5-log-mib)
A list of port group management objects which pertains to a single instance of a port group residing on this ring. - Token Ring Port Group Ring Ports Enable
- tRingPortGrpRingPortsEnable 1.3.6.1.4.1.52.4.1.2.1.1.2.1.1.6 (defined in dot5-log-mib)
Setting this object to enable will cause all the ring ports in this port group to be enabled. Setting this object to noEnable will have no effect on the ring ports in this port group. When read this object will always return noEnable. - Token Ring Port Group Speed Fault Location
- tRingPortGrpSpeedFaultLocation 1.3.6.1.4.1.52.4.1.2.1.1.2.1.1.12 (defined in dot5-log-mib)
This object indicates the last ring speed fault detection circuit(s) to detect the fault, if there was one. - Token Ring Port Management Port Id
- tRingPortMgmtPortId 1.3.6.1.4.1.52.4.1.2.1.1.3.1.1.1.1 (defined in dot5-log-mib)
Returns an index to a port for which the information in this table pertains. - Token Ring Port Management Ring Out Enable
- tRingPortMgmtRingOutEnable 1.3.6.1.4.1.52.4.1.2.1.1.3.1.1.1.8 (defined in dot5-log-mib)
This object, when written, permits the port to function as either a ring out port or a station port, if available. If this selection is not supported by this port, then any write to this object will return a BADSETINFO error. When read, this object will return the state of the port with respect to this mode of operation. The default state of this object, if available, is disabled; otherwise it is notAvailable. - Token Ring Port Station Table
- tRingPortStnTable 1.3.6.1.4.1.52.4.1.2.1.1.3.2.1 (defined in dot5-log-mib)
A list of station port management objects which pertains to a collection of station ports in a port group residing on this ring. - Token Ring Port Station Port Id
- tRingPortStnPortId 1.3.6.1.4.1.52.4.1.2.1.1.3.2.1.1.1 (defined in dot5-log-mib)
Returns an index to a port for which the information in this table pertains. - Token Ring Port Station Port Mapped Mac Address
- tRingPortStnPortMappedMacAddr 1.3.6.1.4.1.52.4.1.2.1.1.3.2.1.1.6 (defined in dot5-log-mib)
This object reports the MAC address of the station mapped to this port, if known. If unknown, the NULL address is returned. - Token Ring Port Ring Table
- tRingPortRingTable 1.3.6.1.4.1.52.4.1.2.1.1.3.3.1 (defined in dot5-log-mib)
A list of ring port management objects which pertains to a collection of ring ports in a port group residing on this ring. - Token Ring Port Ring Port Group Id
- tRingPortRingPortGrpId 1.3.6.1.4.1.52.4.1.2.1.1.3.3.1.1.2 (defined in dot5-log-mib)
Returns an index to a port group to which the port belongs for which the information in this table pertains. - Token Ring Port Ring Fault State Time
- tRingPortRingFaultStateTime 1.3.6.1.4.1.52.4.1.2.1.1.3.3.1.1.6 (defined in dot5-log-mib)
This object reports the amount of time in TimeTicks since the ring port fault state last changed.
