max_time monitor - SNMP OIDs

MIBs list

OIDs - max_time

The objects described here can be monitored with the IPHost Network Monitor. You can start SNMP monitoring using free 30-day trial version of IPHost right now.

OID list for max time

igmp Snoop Query Max Response Time
igmpSnoopQueryMaxResponseTime 1.3.6.1.4.1.43.10.37.1.5 (defined in A3COM0073IGMP-SNOOP)
The maximum query response time in seconds advertised in IGMP v2 queries on this VLAN if the switch is the querier. Smaller values allow a switch to prune groups faster. So it is the maximum response time inserted into the general periodic queries. This variable enables the tuning of the burstiness of the IGMP traffic. If it is increased the responses have a larger time span in which to be generated by the hosts. It is set stack-wide. The default is 10 seconds and the range is 10 to 100 seconds. There could be 2 settings apart from the default. Slow Response (50 secs) and Very Slow Response (100 secs).
a3 Com Poll Max Round Trip Time
a3ComPollMaxRoundTripTime 1.3.6.1.4.1.43.29.4.22.1.1.12 (defined in A3COM-SWITCHING-SYSTEMS-POLL-MIB)
The maximum amount of time taken, in msecs, for the round trip of a ping packet.
atm LAN Emulation Client Max Unknown Frame Time
atmLecMaxUnknownFrameTime 1.3.6.1.4.1.800.2.4.8.1.1.13 (defined in XYLAN-ATM-MIB)
C11 Maximum Unknown Frame Time. Within the period of time defined by the Maximum Unknown Frame Time, a LE Client will send no more than Maximum Unknown Frame Count frames to the BUS for a given unicast LAN Destination, and it must also initiate the address resolution protocol to resolve that LAN Destination. This time value is expressed in seconds.
IBM APPN Node Link Stations Max Delay Time
ibmappnNodeLsMaxDelayTime 1.3.6.1.4.1.2.6.2.13.1.5.1.1.35 (defined in rfc1593)
The time (since system up in hundredth of seconds) when the longest delay occurred. This time can be used to identify when this high water mark occurred in relation to the last initialization of the APPN node.
Cabletron IGMP Vlan Query Max Response Time
ctIGMPVlanQueryMaxResponseTime 1.3.6.1.4.1.52.4.1.3.5.1.2.1.6 (defined in ctron-igmp-mib)
The maximum query response time advertised in IGMPv2 queries on this Vlan.
sfps Flood Counters Max Drops Time
sfpsFloodCountersMaxDropsTime 1.3.6.1.4.1.52.4.2.4.2.2.6.2.1.1.1.7 (defined in ctron-sfps-diagstats-mib)
The time tick on when the maximum drops occurred for that Source MAC.
sfps Resolve Statistics Max Response Time
sfpsResolveStatsMaxResponseTime 1.3.6.1.4.1.52.4.2.4.2.2.2.4.1.3.30 (defined in ctron-sfps-resolve-mib)
sfps Mobility Statistics Max Respone Time
sfpsMobilityStatsMaxResponeTime 1.3.6.1.4.1.52.4.2.4.2.2.9.2.3.51 (defined in ctron-sfps-resolve-mib)
(msec)
vlan Sflsp General Max Time Us
vlanSflspGeneralMaxTimeUs 1.3.6.1.4.1.52.4.2.12.1.2.7.1.1.11 (defined in ctron-sfps-sflsp-mib)
Maximum length of time to process events on the queue
vlan Sflsp General Max Time Occurred
vlanSflspGeneralMaxTimeOccurred 1.3.6.1.4.1.52.4.2.12.1.2.7.1.1.14 (defined in ctron-sfps-sflsp-mib)
Maximum length of time occurred at this time
vlan Sflsp LSP Statistics Max Time Us
vlanSflspLSPStatsMaxTimeUs 1.3.6.1.4.1.52.4.2.12.1.2.7.21.3 (defined in ctron-sfps-sflsp-mib)
vlan Sflsp LSP Statistics Max Time Occurred
vlanSflspLSPStatsMaxTimeOccurred 1.3.6.1.4.1.52.4.2.12.1.2.7.21.5 (defined in ctron-sfps-sflsp-mib)
igmp Snoop Query Max Response Time
igmpSnoopQueryMaxResponseTime 1.3.6.1.4.1.52.4.12.30.1.9.5 (defined in v2h124-24-mib)
expected from an endstation. If a querier has sent a number of queries defined by igmpSnoopQueryCount, but an endstation has not responded, a countdown timer is started using an initial value set by igmpSnoopQueryMaxResponseTime. If the countdown finishes, and the endstation still has not responded, then that the endstation is deemed to have left the multicast group.
Enterasys Flow Limiting Interface Flow Count Max Time
etsysFlowLimitingIntfFlowCountMaxTime 1.3.6.1.4.1.5624.1.2.43.1.3.1.1.8 (defined in enterasys-flow-limiting-mib)
The TimeTicks since the maximum number of flows was recorded. This information is always available and current.
Enterasys Flow Limiting Interface Setup Rate Max Time
etsysFlowLimitingIntfSetupRateMaxTime 1.3.6.1.4.1.5624.1.2.43.1.3.1.1.12 (defined in enterasys-flow-limiting-mib)
The TimeTicks since the maximum flow setup rate was recorded. This information is always available and current.
bsn Ping Test Max Time Interval
bsnPingTestMaxTimeInterval 1.3.6.1.4.1.14179.2.7.2.1.1.6 (defined in AIRESPACE-WIRELESS-MIB)
Maximum time interval in msec.
appn Link Station Max Delay Time
appnLsMaxDelayTime 1.3.6.1.2.1.34.4.1.1.5.1.1.28 (defined in APPN-MIB)
The time when the longest delay occurred. This time can be used to identify when this high water mark occurred in relation to other events in the APPN node, for example, the time at which an APPC session was either terminated or failed to be established. This latter time is available in the appcHistSessTime object in the APPC MIB. The value 00000000 is returned if no test signal has been sent and returned.
Cisco AON End Point Max Response Time
caonEndPointMaxResponseTime 1.3.6.1.4.1.9.9.646.1.1.10.1.9 (defined in CISCO-AON-STATUS-MIB)
This object indicates the maximum response time experienced by the PEP to receive a response from the end point.
Cisco Class Based Qos RED Class Configuration Max Threshold Time
cbQosREDClassCfgMaxThresholdTime 1.3.6.1.4.1.9.9.166.1.11.1.1.9 (defined in CISCO-CLASS-BASED-QOS-MIB)
The maximum WRED threshold value specified in milli-seconds. The milli-second value is internally converted to bytes by using the bandwidth that is available for the class.
Cisco DOCSIS If Cmts Cable Modem Status Max Online Time
cdxIfCmtsCmStatusMaxOnlineTime 1.3.6.1.4.1.9.9.116.1.3.2.1.6 (defined in CISCO-DOCS-EXT-MIB)
The maximum period of time the modem stayed 'online' over the time period from the modem's first ranging message received by CMTS until now. The modem is considered as 'online' when the value for cdxCmtsCmStatusValue is any of the values: online(5), onlineNetAccessDisabled(6), onlineKekAssigned(7), and onlineTekAssigned(8), and the modem is considered as 'offline' for other values for cdxCmtsCmStatusValue.
Cisco DOCSIS If Cmts Cable Modem Status Max Offline Time
cdxIfCmtsCmStatusMaxOfflineTime 1.3.6.1.4.1.9.9.116.1.3.2.1.9 (defined in CISCO-DOCS-EXT-MIB)
The maximum period of time the modem stayed 'offline' over the time period from the modem's first ranging message received by CMTS until now. The modem is considered as 'online' when the value for cdxCmtsCmStatusValue is any of the values: online(5), onlineNetAccessDisabled(6), onlineKekAssigned(7), and onlineTekAssigned(8), and the modem is considered as 'offline' for other values for cdxCmtsCmStatusValue.
Cisco Dns Max Сounter Ha Server No Response Time
cDnsMaxCntrHaSvrNoRespTime 1.3.6.1.4.1.9.9.405.1.10.3 (defined in CISCO-DNS-SERVER-MIB)
Total time in seconds, where the partner of the server was not responding.
Cisco Dns Max Сounter Ha Server Max No Response Time
cDnsMaxCntrHaSvrMaxNoRespTime 1.3.6.1.4.1.9.9.405.1.10.4 (defined in CISCO-DNS-SERVER-MIB)
Maximum contiguous time in seconds, where the partner of the server was not responding.
Cisco Dns Max Сounter Interval Ha Server No Response Time
cDnsMaxCntrIntHaSvrNoRespTime 1.3.6.1.4.1.9.9.405.1.11.3 (defined in CISCO-DNS-SERVER-MIB)
Total time in seconds, where the partner of the server was not responding during reporting interval.
Cisco Dns Max Сounter Interval Ha Server Max No Response Time
cDnsMaxCntrIntHaSvrMaxNoRespTime 1.3.6.1.4.1.9.9.405.1.11.4 (defined in CISCO-DNS-SERVER-MIB)
Maximum time in seconds, where the partner of the server was not responding during reporting interval.
Cisco Dns Max Сounter Interval Sample Time
cDnsMaxCntrIntSampleTime 1.3.6.1.4.1.9.9.405.1.11.10 (defined in CISCO-DNS-SERVER-MIB)
The time stamp of last sample.
Cisco DOT11 Interfaces Max Channel Switch Time
cd11IfMaxChannelSwitchTime 1.3.6.1.4.1.9.9.272.1.1.2.15.1.9 (defined in CISCO-DOT11-IF-MIB)
The maximum time required for the radio interface to switch its transceiver from one channel to any other supported channel in any supported band.
Cisco Fibre Element If Capability Hold Time Max
fcIfCapHoldTimeMax 1.3.6.1.4.1.9.9.289.1.1.7.1.10 (defined in CISCO-FC-FE-MIB)
The maximum holding time ( in microseconds ) that the FC-Port is capable of supporting.
Fibre Channel Management Fx Port Capability Hold Time Max
cfcmFxPortCapHoldTimeMax 1.3.6.1.4.1.9.10.999999.1.7.1.11 (defined in CISCO-FC-MGMT-MIB)
The maximum holding time that this Fx_Port is capable of supporting.

MIBs list