With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.
icfConfigBootpEnable
HP ICF Config Bootp Enable
1.3.6.1.4.1.11.2.14.5.3
********* THIS OBJECT IS DEPRECATED ********* Setting this flag to 'enabled' (the default) will clear any existing IP address configuration for this device, and will cause the device to use the Bootp protocol to obtain its IP configuration after the next reset. This flag must be set to 'disabled' in order to configure an IP address for the device. Setting this flag to 'disabled' will prevent the Bootp protocol from running. Setting this flag to 'disabled' when there is no IP address configured will disable the IP protocol stack on this device.
Back to hpprocurve-v2-icfetwst MIB page.
IPHost Network monitor allows you to monitor icfConfigBootpEnable on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.
