jetsend-contact-ip-address-security - jetsend-contact-ip-address-security - hpclj4500

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.

jetsend-contact-ip-address-security

jetsend-contact-ip-address-security
1.3.6.1.4.1.11.2.3.9.4.2.1.3.8.3.1.2

A C structure containing the following fields: typedef struct { ubyte reserved[3]; ubyte command; /* command: 0 to 1 */ ubyte password[8]; ubyte IPAddress[4]; } jetsend_contact_ip_address_security_t; where ubyte is an unsigned byte (0-255). The defined values defined for command are: 0: Limit JetSend sessions to sessions from a device whose IP address matchs the supplied IPAddress. 1: Limit JetSend sessions to session from devices whose IP addresses match the mask supplied in IPAddress field. If the result of logically anding the mask value supplied in the IPAddress field with the sending device's IP address matches the result of logically anding the mask value supplied in the IPAddress field with this device's IP address, then JetSend will allow the session to be established. To disable IP address security, zero out the IPAddress field. Additional information: Controls the device or class of device(s) which may communicate with the JetSend processing subsystem. The following C data structure contains the relevant fields (described in subsequent paragraphs): typedef struct { unsigned char reserved[3]; unsigned char command; unsigned char password[8]; unsigned char IPAddress[4]; } The 'reserved' field is not used and should remain zero-filled. The 'command' field interpretation differs based on its value: 0 = Accept session(s) only from the specific device whose IP address matches the specified IP address; all other session request(s) from non-matching device(s) are rejected. 1 = Accept session(s) only from the specific device(s) whose IP address(es) conform to the mask specified in the 'IPAddress' field; all other session request(s) from device(s) with non-matching submask(s) are rejected. (If the result of logically AND'ing the mask value supplied in the 'IPAddress' field with the sending device's IP address matches the result of logically AND'ing the mask value supplied in the 'IPAddress' field with this device's IP address, then JetSend will allow session establishment. Password absence/presence determines whether the device will allow the caller to alter the IP address security. If the password is disabled, the caller may set the 'command' and 'IPAddress' fields directly. If the password is enabled, the caller may (re-)set the 'command' and 'IPAddress' fields only after specifying the matching 'password' field. (Refer to the aforementioned 'JETSEND-CONTACT-PASSWORD' object ID.) (Specifying either an invalid 'command' field value or a 'password' field greater than eight (8) bytes or an 'IPAddress' field greater than four (4) bytes causes the error to be returned.)

Back to hpclj4500 MIB page.

IPHost Network monitor allows you to monitor jetsend-contact-ip-address-security on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco switches right now.

MIBs list