xdsl2LineCmndAutomodeColdStart - xdsl2 Line Cmnd Automode Cold Start - VDSL2-LINE-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

xdsl2LineCmndAutomodeColdStart

xdsl2 Line Cmnd Automode Cold Start
1.3.6.1.4.1.2011.2.25.251.1.1.1.1.10

Automode cold start forced. This parameter is defined in order to improve testing of the performance of xTUs supporting automode when it is enabled in the MIB. Change the value of this parameter to 'true' to indicate a change in loop conditions applied to the devices under the test. The xTUs shall reset any historical information used for automode and for shortening G.994.1 handshake and initialization. Automode is the case where multiple operation-modes are enabled through the xdsl2LConfProfXtuTransSysEna object in the line configuration profile being used for the line, and where the selection of the actual operation-mode depends not only on the common capabilities of both xTUs (as exchanged in G.994.1), but also on achievable data rates under given loop conditions.

Back to VDSL2-LINE-MIB MIB page.

IPHost Network monitor allows you to monitor xdsl2LineCmndAutomodeColdStart on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco mobile switches right now.

Easy monitoring of xdsl2LineCmndAutomodeColdStart with IPHost tools

MIBs list