swFCPortPhyState - Switch Fibre Channel Port Phy State - SW-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Dell device in your network.

swFCPortPhyState

Switch Fibre Channel Port Phy State
1.3.6.1.4.1.1588.2.1.1.1.6.2.1.3

the port: noCard(1) no card present in this switch slot; noGbic(2) no GBIC module in this port; laserFault(3) the module is signaling a laser fault (defective GBIC); noLight(4) the module is not receiving light; noSync(5) the module is receiving light but is out of sync; inSync(6) the module is receiving light and is in sync; portFault(7) the port is marked faulty (defective GBIC, cable or device); diagFault(8) the port failed diagnostics (defective G_Port or FL_Port card or motherboard); lockRef(9) the port is locking to the reference signal. ::= { swFCPortEntry 3 } SYNTAX INTEGER { unknown (0), online (1), offline (2), testing (3), faulty (4) } ACCESS read-only STATUS mandatory DESCRIPTION "This object identifies the operational status of the port. The online(1) state indicates that user frames can be passed. The unknown(0) state indicates that likely the port module is physically absent (see swFCPortPhyState).

Back to SW-MIB MIB page.

IPHost Network monitor allows you to monitor swFCPortPhyState on Dell device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Dell servers right now.

Easy monitoring of swFCPortPhyState with IPHost tools

MIBs list