vs Framer Egress Gain

1.3.6.1.4.1.562.2.4.1.80.2.12.1.19

This attribute specifies the gain in dB that is applied to data before it leaves the network. It applies to voice, modem and fax traffic. For example, egress gain is applied to audio data going to a PBX. If egressAudioGain is negative, a loss is applied. If this voice service is running on a DS1V, E1V, 1pDS1V, 1pE1V or J2MV card, egressAudioGain can be set to -6, -4, -2, 0, 2, 4 or 6. If this voice service is running on any other cardType, egressAudioGain can be set to any integral value from -12 to +12. ingressAudioGain and egressAudioGain are used in loss planning, which is the configuration of the devices in the network to ensure that the signal level from any point in the network to any other point is correct.