tdmaCsV42T400DetectTimer - tdma Cs V42 T400 Detect Timer

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

tdmaCsV42T400DetectTimer

tdma Cs V42 T400 Detect Timer

This attribute specifies the maximum amount of time that the IWF waits for an Originator Detection Pattern (ODP) or Answerer Detection Pattern (ADP). ODP/ADP is a series of special bit patterns used during the call setup procedures. If the IWF is the originator of the call, it starts sending ODP patterns and waits for an ADP for the duration of T400 from the answerer at call setup time. If the IWF is the answerer of the call, it waits for an ODP for T400 seconds from the originator and if it receives during that time it sends an ADP pattern to the originator at the call setup time. Since both sides operate with different values of T400 timer, a higher value increases the chance of a successful call setup. Changes to this attribute do not affect existing calls.

Back to Nortel-Magellan-Passport-TdmaIwfMIB MIB page.

IPHost Network monitor allows you to monitor tdmaCsV42T400DetectTimer on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.

Easy monitoring of tdmaCsV42T400DetectTimer with IPHost tools

MIBs list