mpanlSigProtocolErrors - mpanl Sig Protocol Errors

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

mpanlSigProtocolErrors

mpanl Sig Protocol Errors

This attribute counts the number of times a Q.933 protocol error has occurred. Any one of the following events constitutes a protocol error: 1. In the user-signaled Link Layer Core Parameters IE within the SETUP or CONNECT messages, Cir, Bc and Be are all zero; 2. In the user-signaled Link Layer Core Parameters IE within the SETUP or CONNECT messages, Cir is zero but Bc is non-zero, or Bc is zero but Cir is non-zero; 3. In the user-signaled Link Layer Core Parameters IE within the SETUP or CONNECT messages, the minimum acceptable Cir is greater than Cir; 4. At the destination end, any of the destination to source direction link layer core parameters has been increased in the CONNECT message from the called user; 5. At the destination end, the destination to source direction Cir in the CONNECT message is smaller than the corresponding minimum acceptable Cir signaled to the called user; 6. At the source end, any of the source to destination direction link layer core parameters in the CONNECT message from the destination end has been increased; 7. At the source end, the source to destination direction Cir, after negotiation, is smaller than the corresponding minimum acceptable Cir; 8. The network has received a STATUS message from the user with an incompatible Q.933 state. When this count reaches maximum, it wraps to zero.

Back to Nortel-Magellan-Passport-MpaNetworkLinkMIB MIB page.

IPHost Network monitor allows you to monitor mpanlSigProtocolErrors on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel speech servers right now.

Easy monitoring of mpanlSigProtocolErrors with IPHost tools

MIBs list