lpImaStandbyStatus - lp Ima Standby Status

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

lpImaStandbyStatus

lp Ima Standby Status

If supported by the component, this attribute indicates the OSI Standby status of the component. The value notSet indicates that either the attribute is not supported or that none of the status conditions described below are present. Note that this is a non-standard value, used because the original specification indicated this attribute was set-valued and thus, did not provide a value to indicate that none of the other three are applicable. The value hotStandby indicates that the resource is not providing service but will be immediately able to take over the role of the resource to be backed up, without initialization activity, and containing the same information as the resource to be backed up. The value coldStandby indicates the resource is a backup for another resource but will not be immediately able to take over the role of the backed up resource and will require some initialization activity. The value providingService indicates that this component, as a backup resource, is currently backing up another resource.

Back to Nortel-Magellan-Passport-ImaMIB MIB page.

IPHost Network monitor allows you to monitor lpImaStandbyStatus on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.

Easy monitoring of lpImaStandbyStatus with IPHost tools

MIBs list