htdsPlcPathType - htds Plc Path Type

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

htdsPlcPathType

htds Plc Path Type

This attribute specifies if the path for this PLC is determined automatically or by static provisioning. The default (normal) is to automatically choose a route with Route Selection. Normal pathTypes require less provisioning and can dynamically handle path failures. The other pathTypes are both manual pathTypes where the operator must specify, through provisioning, a static route termed the manualPath. A manual pathType connection is nearly identical to a normal path type connection with the exception that the route is pre-provisioned. For a manual pathType, bandwidth reservations are respected along the path exactly as in a normal path. The last type, the forced pathType, is also a manual path but regardless of the bandwidth available the route is granted provided the trunks are operational and there are sufficient Logical Channels (LChs). The forced pathType could result in over committing the reserved bandwidth allowed on a trunk. A better way to achieve the effects of a forced pathType is to use a manual pathType with setupPriority = 0 and holdingPriority = 0. In this manner the path will reserve correct bandwidth and it will bump other paths if required while not being bumped itself.

Back to Nortel-Magellan-Passport-HdlcTransparentMIB MIB page.

IPHost Network monitor allows you to monitor htdsPlcPathType on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel switches right now.

Easy monitoring of htdsPlcPathType with IPHost tools

MIBs list