frUniDnaDataPath - Frame Relay Uni Dna Data Path

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

frUniDnaDataPath

Frame Relay Uni Dna Data Path

This attribute specifies the data path to be used by Virtual Circuits on this interface. If the connection has a DirectCall component then the value can be overridden by the dataPath attribute of the DirectCall component. This value applies to the connection after data transfer state is reached. All the data and control trafic will be sent using this data path. If the provisioned dataPath is not available the connection is not established. The value of the dataPath is signalled by both ends of the connection. If this value is not the same at both ends dprsOnly is used for the duration of the connection. A virtual circuit connection is always established using dprsOnly even if this attribute is provisioned as some other value. dprsOnly - dynamic packet routing system is used dprsMcsOnly - dprs Multi-Service Cut-Through Switching path is used. dprsMcsFirst - dprs Multi-Service Cut-Through Switching path is used if it is available. If it is not avaliable dprsOnly is used.

Back to Nortel-Magellan-Passport-FrameRelayUniMIB MIB page.

IPHost Network monitor allows you to monitor frUniDnaDataPath on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel modems right now.

Easy monitoring of frUniDnaDataPath with IPHost tools

MIBs list