frNniLtsAlgorithm - Frame Relay Nni Lts Algorithm

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

frNniLtsAlgorithm

Frame Relay Nni Lts Algorithm

This attribute specifies which algorithm is used to generate the frames. ContinuousBurst This mode of traffic generation creates traffic at the maximum rate possible until all of the frames have been sent. The generator then waits until the end of the timeInterval to begin again. IntervalBurst This algorithm attempts to generate 10 ms bursts of burstSize frames. It will generate as many of the burstSize frames as it can per sub-interval. DelayedBurst This algorithm generates bursts of burstSize frames separated by 10 ms delays. FixedBurst This aglorithm is similar to IntervalBurst, except a fixed burst size of 12 frames is used. delayMeasurement This algorithm is used to measure delay. The specified number of frames in the indicated pattern are generated, one at a time, with a maximum wait of maxDelay before sending the next frame. This algorithm is not implemented yet.

Back to Nortel-Magellan-Passport-FrameRelayNniMIB MIB page.

IPHost Network monitor allows you to monitor frNniLtsAlgorithm on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel speech servers right now.

Easy monitoring of frNniLtsAlgorithm with IPHost tools

MIBs list