frNniLmiProtocolStatus - Frame Relay Nni Lmi Protocol Status

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

frNniLmiProtocolStatus

Frame Relay Nni Lmi Protocol Status

This attribute indicates whether the LMI is in an error condition or whether the LMI procedures are behaving normally. When operating with no LMI protocol, this attribute is always set to normalCondition. When operating with LMI procedures, this attribute is set to errorCondition after n392 of the last n393 events are in error. The consequence of an errorCondition is that all DLCIs on this interface will become inactive in both directions. The errorCondition is lifted and a normalCondition is indicated when a sufficient number of events have occurred without error. In ANSI, this occurs when n393 consecutive good events take place. If the procedures attribute is set to autoConfigure, this attribute is se to configuring while adaptive LMI determines which LMI procedures are running on the link. A single LMI error event during auto configuration causes the attribute value to change to errorCondition. If during configuring no LMI message is received, an LMI errorCondition is raised after n392 x t392 seconds.

Back to Nortel-Magellan-Passport-FrameRelayNniMIB MIB page.

IPHost Network monitor allows you to monitor frNniLmiProtocolStatus on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel modems right now.

Easy monitoring of frNniLmiProtocolStatus with IPHost tools

MIBs list