With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.
frNniDlciLoopbackState
Frame Relay Nni Dlci Loopback State
This attribute has the value on when the DLCI is in loopback mode and off otherwise. This loopback command verbs start and stop are used to initiate and terminate the loopback mode for a DLCI. While loopbackState is on, the local LMI will report to the interface the A- bit status as active. Also an active A-bit signal will be reliably propagated across the subnet to the remote DLCI.
Back to Nortel-Magellan-Passport-FrameRelayNniMIB MIB page.
IPHost Network monitor allows you to monitor frNniDlciLoopbackState on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel multiplexers right now.
