Frame Relay Dte Error Type

The type of error that was last seen on this interface. The error types are as follows: receiveShort: This error indicates a received frame was discarded because it was less than four octets long or it was missing the Organizationally Unique Identifier (OUI) for a SNAP header. receiveLong: This error indicates a received frame was discarded because it was longer than expected. This error is currently not used on this interface. illegalDlci: This error indicates that a received frame was discarded because it's Q.922 address was not two octets in length. This error could also indicate that a frame was discarded because it was received on a DLCI reserved for LMI which had not been provisioned active. dlcmiProtoErr: This error indicates an LMI frame was received with contents formatted incorrectly. dlcmiUnknownIe: This error indicates that an LMI frame was received which contained an unsupported Information Element (IE) type dlcmiSequenceErr: This error indicates that an LMI frame was received whose Keep Alive Sequence was incorrect. dlcmiUnknownRpt: This error indicates that an LMI frame was received which contained a Report-type Information Element with an invalid type of report. noErrorSinceReset: This error type indicates that there has not been an error since the interface has been reset. unknownError: This error type contains the cumulation of receive frame errors that did not fit one of the MIB error descriptions above. These errors include those counted by the following attributes: ulpUnknownProtocol - A received frame was discarded because the Upper Level Protocol (ULP) encapsulation used was unsupported. badFc - A received frame was discarded because the frame control character was incorrect. defragSequenceErrors - A fragment was received which was discarded due to an out of sequence error detection.