frAtmLmiOpProcedures - Frame Relay Atm Lmi Operation Procedures

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

frAtmLmiOpProcedures

Frame Relay Atm Lmi Operation Procedures

The opProcedures attribute indicates the procedures being used for the Local Management Interface. This attribute should be ignored if protocolStatus is not normalCondition. The following procedures are supported: none: Local Management Interface procedures are not running on this interface. This accommodates Frame Relay user equipment that has not implemented any LMI procedures. vendorForum: Local Management Interface procedures from the Vendor Forum specification are running on this interface. DLCI 1023 is used for the LMI protocol. ansi: Local Management Interface procedures from the ANSI specification are running. DLCI 0 is used for the LMI protocol. itu: Local Management Interface procedures from the ITU-T specification are running. DLCI 0 is used for the LMI protocol. Was previously ccitt. unknown: Local Management Interface procedures have yet to be determined by Adaptive LMI.

Back to Nortel-Magellan-Passport-FrameRelayAtmMIB MIB page.

IPHost Network monitor allows you to monitor frAtmLmiOpProcedures on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.

Easy monitoring of frAtmLmiOpProcedures with IPHost tools

MIBs list