btdsPlcRequiredRxBandwidth - btds Plc Required Rx Bandwidth

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

btdsPlcRequiredRxBandwidth

btds Plc Required Rx Bandwidth

This attribute gives the bandwidth (in bits per second) reserved by a path on each of trunks of its route. This attribute represents the bandwidth for traffic incoming from the remote end point. This value should be chosen to achieve the amount of statistical bandwidth sharing that is desired by the network administration. This reservation is not enforced and is used to determine how many paths can be supported on a trunk. Both ends should be provisioned with the correct values allowing for the fact that transmit at this end represents receive at the remote end. Note that when the values do not correspond, the originating end of the connection determines the value.

Back to Nortel-Magellan-Passport-BitTransparentMIB MIB page.

IPHost Network monitor allows you to monitor btdsPlcRequiredRxBandwidth on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel modems right now.

Easy monitoring of btdsPlcRequiredRxBandwidth with IPHost tools

MIBs list