atmIfVpcSrcLastFailureDiagCode - atm If Vpc Source Last Failure Diag Code

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

atmIfVpcSrcLastFailureDiagCode

atm If Vpc Source Last Failure Diag Code

This attribute contains the diagnostic code in the last transmitted signalling message. The diagnostic code is contained in the CAUSE information element and identifies an information element type or timer type. The diagnostic code is present only if a procedural error is detected by the signalling protocol. A diagnostic code is always accompanied by the cause code. If there is no failure, this attribute is set to NULL.

Back to Nortel-Magellan-Passport-AtmNetworkingMIB MIB page.

IPHost Network monitor allows you to monitor atmIfVpcSrcLastFailureDiagCode on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel secure routers right now.

Easy monitoring of atmIfVpcSrcLastFailureDiagCode with IPHost tools

MIBs list