atmIfVptIispSigVcdUsageParameterControl - atm If Vpt Iisp Sig Vcd Usage Parameter Control

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Nortel device in your network.

atmIfVptIispSigVcdUsageParameterControl

atm If Vpt Iisp Sig Vcd Usage Parameter Control

This attribute specifies whether this connection enforces usage parameter control when receiving traffic from the ATM interface. When sameAsCa is selected, UPC for the connection is based on the usageParameterControl attribute of the connection's service category component under the ConnectionAdministrator. If the service category has UPC enabled, then UPC is enabled for the connection. Note that enabling UPC may have no effect under certain cases. These cases are listed in the description of the usageParameterControl operational attribute, which is under the Vcc Tm or Vpc Tm component. When disabled is selected, UPC for this connection is disabled. The value sameAsInterface is for migration from previous software releases, but should no longer be used

Back to Nortel-Magellan-Passport-AtmIispMIB MIB page.

IPHost Network monitor allows you to monitor atmIfVptIispSigVcdUsageParameterControl on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Nortel switches right now.

Easy monitoring of atmIfVptIispSigVcdUsageParameterControl with IPHost tools

MIBs list