agentSwitchBroadcastControlMode ( agent Switch Broadcast Control Mode ) from NETGEAR-SWITCHING-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a NETGEAR device in your network.

agentSwitchBroadcastControlMode

agent Switch Broadcast Control Mode
1.3.6.1.4.1.4526.10.1.2.8.2

The switch config broadcast allows you to enable or disable broadcast storm recovery mode. When you specify Enable for Broadcast Storm Recovery and the broadcast traffic on any Ethernet port exceeds 20 percent of the link speed, the switch blocks (discards) the broadcast traffic until the broadcast traffic returns to 10 percent or less. Upper limit for 10M link is 20% and lower limit is 10%. For 100M link Upper limit is 5% and lower limit is 2%

Back to NETGEAR-SWITCHING-MIB MIB page.

IPHost Network monitor allows you to monitor agentSwitchBroadcastControlMode on NETGEAR device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring NETGEAR cable modems right now.

Easy monitoring of agentSwitchBroadcastControlMode with IPHost tools

MIBs list