agentRouterOspfRFC1583CompatibilityMode ( agent Router Ospf RFC1583 Compatibility Mode ) from NETGEAR-ROUTING-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a NETGEAR device in your network.

agentRouterOspfRFC1583CompatibilityMode

agent Router Ospf RFC1583 Compatibility Mode
1.3.6.1.4.1.4526.10.2.4.11

From RFC2328: Controls the preference rules used in Section 16.4 when choosing among multiple AS-external-LSAs advertising the same destination. When set to 'enabled', the preference rules remain those specified by RFC 1583 ([Ref9]). When set to 'disabled', the preference rules are those stated in Section 16.4.1, which prevent routing loops when AS- external-LSAs for the same destination have been originated from different areas. Set to 'enabled' by default. In order to minimize the chance of routing loops, all OSPF routers in an OSPF routing domain should have RFC1583Compatibility set identically. When there are routers present that have not been updated with the functionality specified in Section 16.4.1 of this memo, all routers should have RFC1583Compatibility set to 'enabled'. Otherwise, all routers should have RFC1583Compatibility set to 'disabled', preventing all routing loops.

Back to NETGEAR-ROUTING-MIB MIB page.

IPHost Network monitor allows you to monitor agentRouterOspfRFC1583CompatibilityMode on NETGEAR device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring NETGEAR WiFi routers right now.

Easy monitoring of agentRouterOspfRFC1583CompatibilityMode with IPHost tools

MIBs list