mplsTunnelIndexNext - mpls Tunnel Index Next - MPLS-TE-STD-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

mplsTunnelIndexNext

mpls Tunnel Index Next

This object contains an unused value for mplsTunnelIndex, or a zero to indicate that none exist. Negative values are not allowed, as they do not correspond to valid values of mplsTunnelIndex. Note that this object offers an unused value for an mplsTunnelIndex value at the ingress side of a tunnel. At other LSRs the value of mplsTunnelIndex SHOULD be taken from the value signaled by the MPLS signaling protocol. ::= { mplsTeObjects 1 } SYNTAX SEQUENCE OF MplsTunnelEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION The mplsTunnelTable allows new MPLS tunnels to be created between an LSR and a remote endpoint, and existing tunnels to be reconfigured or removed. Note that only point-to-point tunnel segments are supported, although multipoint-to-point and point- to-multipoint connections are supported by an LSR acting as a cross-connect. Each MPLS tunnel can thus have one out-segment originating at this LSR and/or one in-segment terminating at this LSR.

Back to MPLS-TE-STD-MIB MIB page.

IPHost Network monitor allows you to monitor mplsTunnelIndexNext on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco mobile switches right now.

Easy monitoring of mplsTunnelIndexNext with IPHost tools

MIBs list