mplsL3VpnVrfConfRteMxThrshTime - mpls L3 Vpn Vrf Conf Rte Mx Thrsh Time - MPLS-L3VPN-STD-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

mplsL3VpnVrfConfRteMxThrshTime

mpls L3 Vpn Vrf Conf Rte Mx Thrsh Time

Denotes the interval in seconds, at which the route max threshold notification may be reissued after the maximum value has been exceeded (or has been reached if mplsL3VpnVrfConfMaxRoutes and mplsL3VpnVrfConfHighRteThresh are equal) and the initial notification has been issued. This value is intended to prevent continuous generation of notifications by an agent in the event that routes are continually added to a VRF after it has reached its maximum value. If this value is set to 0, the agent should only issue a single notification at the time that the maximum threshold has been reached, and should not issue any more notifications until the value of routes has fallen below the configured threshold value. This is the recommended default behavior.

Back to MPLS-L3VPN-STD-MIB MIB page.

IPHost Network monitor allows you to monitor mplsL3VpnVrfConfRteMxThrshTime on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of mplsL3VpnVrfConfRteMxThrshTime with IPHost tools

MIBs list