ifMauAutoNegCapability - if Mau Auto Neg Capability - MAU-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ifMauAutoNegCapability

if Mau Auto Neg Capability
1.3.6.1.2.1.26.5.1.1.5

This object has been deprecated in favour of ifMauAutoNegCapabilityBits. A value that uniquely identifies the set of capabilities of the local auto-negotiation entity. The value is a sum which initially takes the value zero. Then, for each capability of this interface, 2 raised to the power noted below is added to the sum. For example, an interface which has the capability to support only 100Base-TX half duplex would have a value of 32768 (2**15). In contrast, an interface which supports both 100Base-TX half duplex and and 100Base-TX full duplex would have a value of 98304 ((2**15) + (2**16)). The powers of 2 assigned to the capabilities are these: Power Capability 0 other or unknown (1-9) (reserved) 10 10BASE-T half duplex mode 11 10BASE-T full duplex mode 12 (reserved) 13 (reserved) 14 100BASE-T4 15 100BASE-TX half duplex mode 16 100BASE-TX full duplex mode 17 (reserved) 18 (reserved) 19 100BASE-T2 half duplex mode 20 100BASE-T2 full duplex mode Note that interfaces that support this MIB may have capabilities that extend beyond the scope of this MIB.

Back to MAU-MIB MIB page.

IPHost Network monitor allows you to monitor ifMauAutoNegCapability on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of ifMauAutoNegCapability with IPHost tools

MIBs list