ifTestType - if Test Type

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Huawei device in your network.

ifTestType

if Test Type
1.3.6.1.2.1.31.1.3.1.3

A control variable used to start and stop operator- initiated interface tests. Most OBJECT IDENTIFIER values assigned to tests are defined elsewhere, in association with specific types of interface. However, this document assigns a value for a full- duplex loopback test, and defines the special meanings of the subject identifier: noTest OBJECT IDENTIFIER ::= { 0 0 } When the value noTest is written to this object, no action is taken unless a test is in progress, in which case the test is aborted. Writing any other value to this object is only valid when no test is currently in progress, in which case the indicated test is initiated. When read, this object always returns the most recent value that ifTestType was set to. If it has not been set since the last initialization of the network management subsystem on the agent, a value of noTest is returned.

Back to IEEE8021-PAE-MIB MIB page.

IPHost Network monitor allows you to monitor ifTestType on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Allied Telesis iMAP chassis right now.

Easy monitoring of ifTestType with IPHost tools

MIBs list