ifStackTable - if Stack Table

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Huawei device in your network.

ifStackTable

if Stack Table
1.3.6.1.2.1.31.1.2

The table containing information on the relationships between the multiple sub-layers of network interfaces. In particular, it contains information on which sub- layers run 'on top of' which other sub-layers, where each sub-layer corresponds to a conceptual row in the ifTable. For example, when the sub-layer with ifIndex value x runs over the sub-layer with ifIndex value y, then this table contains: ifStackStatus.x.y=active For each ifIndex value, I, which identifies an active interface, there are always at least two instantiated rows in this table associated with I. For one of these rows, I is the value of ifStackHigherLayer; for the other, I is the value of ifStackLowerLayer. (If I is not involved in multiplexing, then these are the only two rows associated with I.) For example, two rows exist even for an interface which has no others stacked on top or below it: ifStackStatus.0.x=active ifStackStatus.x.0=active

Back to IEEE8021-PAE-MIB MIB page.

IPHost Network monitor allows you to monitor ifStackTable on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Allied Telesis iMAP chassis right now.

Easy monitoring of ifStackTable with IPHost tools

MIBs list