dot3StatsSQETestErrors - dot3 Stats SQE Test Errors

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Huawei device in your network.

dot3StatsSQETestErrors

dot3 Stats SQE Test Errors
1.3.6.1.2.1.10.7.2.1.6

message is generated by the PLS sublayer for a particular interface. The SQE TEST ERROR is set in accordance with the rules for verification of the SQE detection mechanism in the PLS Carrier Sense Function as described in IEEE Std. 802.3, 1998 Edition, section 7.2.4.6. This counter does not increment on interfaces operating at speeds greater than 10 Mb/s, or on interfaces operating in full-duplex mode. Discontinuities in the value of this counter can occur at re-initialization of the management system, and at other times as indicated by the value of ifCounterDiscontinuityTime.

Back to IEEE8021-PAE-MIB MIB page.

IPHost Network monitor allows you to monitor dot3StatsSQETestErrors on Allied Telesis device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Allied Telesis access points right now.

Easy monitoring of dot3StatsSQETestErrors with IPHost tools

MIBs list