GENERIC-3COM-VLAN-MIB-1-0-6 - a3ComVlanProtocolStatus

MIBs list

a3ComVlanProtocolStatus

a3 Com Vlan Protocol Status
1.3.6.1.4.1.43.10.1.14.2.2.1.3

The status column for this VLAN interface. This OBJECT can be set to: active(1) createAndGo(4) createAndWait(5) destroy(6) The following values may be read: active(1) notInService(2) notReady(3). Setting this object to createAndGo(4) causes the agent to attempt to create and commit the row based on the contents of the objects in the row. If all necessary information is present in the row and the values are acceptible to the agent, the agent will change the status to active(1). If any of the necessary objects are not available, the agent will reject the creation request. Setting this object to createAndWait(5) causes a row in this table to be created. The agent sets the status to notInService(2) if all of the information is present in the row and the values are acceptable to the agent; otherwise, the agent sets the status to notReady(3). Setting this object to active(1) is only valid when the current status is active(1) or notInService(2). Row creation to this table is only possible when a corresponding VLAN entry has been created in the a3ComVlanTable with an a3ComVlanType set to vlanLayeredProtocols(16). Setting this object to destroy(6) will remove the corresponding VLAN interface to protocol mapping.

Back to GENERIC-3COM-VLAN-MIB-1-0-6 MIB page.

IPHost Network monitor uses SNMP for monitoring health and availability of devices and applications in your network. You can send a SNMP Set to any remote device to monitor a specific SNMP object (CPU, Memory, Disk, Server Temperature, RAID failures, IO statistics, connection counts, error and much more).

MIBs list