chas Phy Module Admin Status

1.3.6.1.4.1.22.101.6.1.2.2.2.1.9

Provides desired state of the given physical module. Notice that not all values may be supported by the specified physical module. In this case and SNMP error will be returned when the set is attempted. A physical module maybe activated by writing a value of enable(2). A physical module may be de-activated by writing a value of disable(3). In a disabled state a physical module is present in the chassis but is benign. Writing a value of sw_reset(4) initiates a software reset sequence. Writing a value of hw_reset(7) initiates a hardware reset sequence. A value of programLoad(5) initiates a software load sequence. Writing a value of test(6) should start a self test sequence within the physical module.