docsQosParamSetMaxTrafficRate - DOCSIS Qos Param Set Max Traffic Rate - DOCS-QOS-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

docsQosParamSetMaxTrafficRate

DOCSIS Qos Param Set Max Traffic Rate
1.3.6.1.4.1.2011.2.25.127.7.1.2.1.6

service flow in bits/sec. Must count all MAC frame data PDU from the bytes following the MAC header HCS to the end of the CRC. The number of bytes forwarded is limited during any time interval. The value 0 means no maximum traffic rate is enforced. This object applies to both upstream and downstream service flows. If the referenced parameter is not present in the corresponding DOCSIS QOS Parameter Set, the default value of this object is 0. If the parameter is not applicable, it is reported as 0. REFERENCE "SP-RFIv1.1-I07-010829, Appendix C.2.2.5.2

Back to DOCS-QOS-MIB MIB page.

IPHost Network monitor allows you to monitor docsQosParamSetMaxTrafficRate on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco switches right now.

Easy monitoring of docsQosParamSetMaxTrafficRate with IPHost tools

MIBs list