Compaq Drive Array Controller Stnd Intr

1.3.6.1.4.1.232.3.2.2.1.1.4

The status of the Standard Interface. The Standard Interface is how DOS communicates with a drive. Run the Compaq EISA Configuration Utility to change the Standard Interface setting. The following values are valid for Standard Interface: Other (1) The device driver may not be loaded for this controller. The instrument agent could not read the information from the device. Please load the device driver. Primary (2) The Standard Interface is using the primary address for communication. DOS can access this drive and use this drive as the primary boot device if it has been configured for this purpose. Secondary (3) The Standard Interface is using the secondary address for communication. DOS can access these drives, but cannot boot from them. Disabled (4) The Standard Interface is not enabled for communication. DOS will not be able to access these drives. Unavailable (5) This controller does not support a Standard Interface. DOS cannot access these drives. For example, the Compaq 32-Bit Intelligent Drive Array Expansion Controller does not support a Standard Interface.