vlanTrunkPortVlansEnabled3k - vlan Trunk Port Vlans Enabled3k - CISCO-VTP-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

vlanTrunkPortVlansEnabled3k

vlan Trunk Port Vlans Enabled3k
1.3.6.1.4.1.9.9.46.1.6.1.1.18

A string of octets containing one bit per VLAN for VLANS with VlanIndex values of 2048 through 3071 in the management domain on this trunk port. The first octet corresponds to VLANs with VlanIndex values of 2048 through 2055; the second octet to VLANs 2056 through 2063; etc. The most significant bit of each octet corresponds to the lowest value VlanIndex in that octet. If the bit corresponding to a VLAN is set to '1', then the local system is enabled for sending and receiving frames on that VLAN; if the bit is set to '0', then the system is disabled from sending and receiving frames on that VLAN. The default value is zero length string. To avoid conflicts between overlapping partial updates by multiple managers, i.e., updates which modify only a portion of an instance of this object (e.g., enable/disable a single VLAN on the trunk port), any SNMP Set operation accessing an instance of this object should also write the value of vlanTrunkPortSetSerialNo.

Back to CISCO-VTP-MIB MIB page.

IPHost Network monitor allows you to monitor vlanTrunkPortVlansEnabled3k on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of vlanTrunkPortVlansEnabled3k with IPHost tools

MIBs list