csApsArchMode - cs Aps Arch Mode - CISCO-SONET-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

csApsArchMode

cs Aps Arch Mode
1.3.6.1.4.1.9.9.126.1.2.1.1.4

This object is used to configure APS architecture mode on the working/protection line pairs. All of the following are supported on single slot. oneToOne(2) is not supported across 2 slots,i.e. the working and protection slot numbers must be the same in oneToOne(2). onePlusOne : This can be supported on the same card and across 2 cards. This mode means that the transmit and receive signals go only over the active line(which could be working or protection line). (straight cable implied) oneToOne : This is supported only on the same card This mode means that the transmit and receive signals go over the working and protection lines. (straight cable implied) anexBOnePlusOne : This can be supported on the same card and across 2 cards. This mode is like the onePlusOne mode, except that the 'csApsDirection' can only be bi-directional. (straight cable implied) ycableOnePlusOneNok1k2: With Y-cable ignore K1K2 bytes. This mode is the Y-cable redundancy mode. straightOnePlusOneNok1k2 : With straight cable, ignore K1K2 bytes. This mode is like onePlusOne, but with K1, K2 bytes ignored.

Back to CISCO-SONET-MIB MIB page.

IPHost Network monitor allows you to monitor csApsArchMode on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco mobile switches right now.

Easy monitoring of csApsArchMode with IPHost tools

MIBs list