CISCO-SNAPSHOT-MIB - ciscoSnapshotIfUpAction

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ciscoSnapshotIfUpAction

cisco Snapshot If Up Action
1.3.6.1.4.1.9.9.19.1.2.1.7

This object controls the action that takes place when the interface associated with this entry transitions to the `up' state while snapshot routing on the interface is in quiet mode. A value of goActive will cause the immediate transition to the active state. A value of noAction will cause no such transition. Instead, the transition to the active state will occur normally when the current quiet period has expired. Going active immediately incurs extra routing protocol overhead, but allows a fresh set of routing updates be exchanged each time the line is brought up. This is useful in a Dial-on-Demand routing environment. An instance of this object may only be present if the value of the associated ciscoSnapshotClient object is true.

Back to CISCO-SNAPSHOT-MIB MIB page.

IPHost Network monitor allows you to monitor ciscoSnapshotIfUpAction on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

MIBs list