pagpLearnMethod - pagp Learn Method - CISCO-PAGP-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

pagpLearnMethod

pagp Learn Method
1.3.6.1.4.1.9.9.98.1.1.1.1.7

This interface's learning method value. Specifies whether this device is able to learn the location of a source MAC address based on the agport on which it was received, agPort(2), or on the interface on which it was received, physPort(1). This value is relevant primarily to IEEE 802.1D transparent bridges. If a device does not associate recieved source MAC addresses with the interface on which it arrived, it should use the value agPort(2). The managed device will refuse an attempt to set the value of pagpLearnMethod to undefined(3). A particular device may support either physPort, agPort, or both.

Back to CISCO-PAGP-MIB MIB page.

IPHost Network monitor allows you to monitor pagpLearnMethod on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of pagpLearnMethod with IPHost tools

MIBs list