ciuUpgradeOpCommand - Cisco Image Upgrade Upgrade Op Command

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ciuUpgradeOpCommand

Cisco Image Upgrade Upgrade Op Command
1.3.6.1.4.1.9.9.360.1.1.4.1

The command to be executed. Note that it is possible for a system to support only a subset of these commands. If a command is unsupported, it will complete immediatly with the 'invalidOperation' error being reported in the ciuUpgradeOpStatus object. The 'check' must be performed first before 'install' command can be executed. If 'install' is performed first the operation would fail. So 'install' will be allowed only if a read of this object returns 'check' and the value of object ciuUpgradeOpStatus is 'success'. Also 'check' will be allowed only if a read of this object returns 'none'. Command Remarks none if this object is read without performing any operation listed above, 'none' would be returned. Also 'none' would be returned for a read operation if a cleanup of the previous upgrade operation is completed either through the issue of 'done' command or the maximum timeout of 5 minutes is elapsed. Setting this object to 'none', agent would return a success without any upgrade operation being performed. done if this object returns any value other than 'none', then setting this to 'done' would do the required cleanup of previous upgrade operation and make the system ready for any new upgrade operation. This is needed because the system maintains the status of the previous upgrade operation for a maximum time of 5 minutes before it does the cleanup. During this period no new upgrade operation is allowed. install for all the physical entities listed in the ciuUpgradeTargetTable perform the required upgrade operation listed in that table. However the upgrade operation for a module would not be done if the current running image and the image to be upgraded given as an input through the ciuImageLocInputTable are the same. check check the version compatibility for the given set of image files against the current system configuration. ::= { ciscoImageUpgradeOp 1 } SYNTAX INTEGER { none(1), invalidOperation(2), failure(3), inProgress(4), success(5), abortInProgress(6), abortSuccess(7), abortFailed(8), successReset(9), fsUpgReset(10) } MAX-ACCESS read-only STATUS current DESCRIPTION The status of the specified operation. none(1) - no operation was performed. invalidOperation(2) - the selected operation is not supported. failure(3) - the selected operation has failed. inProgress(4) - specified operation is active. success(5) - specified operation has completed successfully. abortInProgress(6) - abort in progress. abortSuccess(7) - abort operation successful. abortFailed(8) - abort failed. successReset(9) - specified operation has completed successfully and the system will reset. fsUpgReset(10) - fabric switch upgrade reset.

Back to CISCO-IMAGE-UPGRADE-MIB MIB page.

IPHost Network monitor allows you to monitor ciuUpgradeOpCommand on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco wireless switches right now.

Easy monitoring of ciuUpgradeOpCommand with IPHost tools

MIBs list