cpwCTDMRate - Cisco Pseudo Wire CTDM Rate - CISCO-IETF-PW-TDM-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cpwCTDMRate

Cisco Pseudo Wire CTDM Rate
1.3.6.1.4.1.9.10.131.1.1.1.1

The parameter represents the bit-rate of the TDM service in multiples of the 'basic' 64 Kbit/s rate. It complements the definition of cpwVcType used in CISCO-IETF-PW-MIB. For structure-agnostic the following should be used: a) Satop E1 - 32 b) Satop T1 emulation: i) MUST be set to 24 in the basic emulation mode ii) MUST be set to 25 for the 'Octet-aligned T1' emulation mode c) Satop E3 - 535 d) Satop T3 - 699 For all kinds of structure-aware emulation, this parameter MUST be set to N where N is the number of DS0 channels in the corresponding attachment circuit.

Back to CISCO-IETF-PW-TDM-MIB MIB page.

IPHost Network monitor allows you to monitor cpwCTDMRate on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of cpwCTDMRate with IPHost tools

MIBs list