cpwVcEnetPortIfIndex - Cisco Pseudo Wire Vc Enet Port If Index - CISCO-IETF-PW-ENET-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cpwVcEnetPortIfIndex

Cisco Pseudo Wire Vc Enet Port If Index
1.3.6.1.4.1.9.10.108.1.1.1.5

This object is used to specify the ifIndex of the ETHERNET port associated with this VC for point-to-point Ethernet service, or the ifIndex of the virtual interface of the VPLS instance associated with the PW if the service is VPLS. Two rows in this table can point to the same ifIndex only if: 1) It is required to support multiple COS on a MPLS PSN for the same service (i.e.: a combination of ports and VLANs) by the use of multiple VC, each with a different COS. 2) There is no overlap of VLAN values specified in cpwVcEnetPortVlan that are associated with this port. A value of zero indicate that association to an ifIndex is not yet known.

Back to CISCO-IETF-PW-ENET-MIB MIB page.

IPHost Network monitor allows you to monitor cpwVcEnetPortIfIndex on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of cpwVcEnetPortIfIndex with IPHost tools

MIBs list