cHsrpExtIfEntry - Cisco Hot Standby Routing Protocol Ext If Entry

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cHsrpExtIfEntry

Cisco Hot Standby Routing Protocol Ext If Entry
1.3.6.1.4.1.9.9.107.1.2.1.1

If HSRP entries on this interface must use the BIA (Burned In Address), there must be an entry for the interface in this table. Entries of this table are only accessible if HSRP has been enabled i.e entries can not be created if HSRP is not enabled. Also, the interfaces should be of IEEE 802 ones (Ethernet, Token Ring, FDDI,VLAN, LANE, TR-LANE). Setting cHsrpExtIfRowStatus to active initiates the entry with default value for cHsrpExtIfUseBIA as FALSE. The value of cHsrpExtIfRowStatus may be set to destroy at any time. If the row is not initiated, it is similar to having cHsrpExtIfUseBIA as FALSE. Entries may not be created via SNMP without explicitly setting cHsrpExtIfRowStatus to either 'createAndGo' or 'createAndWait'. Entries can be created and modified via the management protocol or by the device's local management interface. If the row is not active, and a local management interface command modifies that row, the row may transition to active state. A row which is not in active state will timeout after a configurable period (five minutes by default). This timeout period can be changed by setting cHsrpConfigTimeout.

Back to CISCO-HSRP-EXT-MIB MIB page.

IPHost Network monitor allows you to monitor cHsrpExtIfEntry on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of cHsrpExtIfEntry with IPHost tools

MIBs list