cDot11RadioDiagMode - Cisco Dot11 Radio Diagnostic Mode

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cDot11RadioDiagMode

Cisco Dot11 Radio Diagnostic Mode
1.3.6.1.4.1.9.10.105.1.1.1.1.3

Test mode as carried by the Cisco Radio Management Extensions in the 802.11 beacon frame. The semantics are described as follows. normal - Indicates that the station is operating in non-test mode. apRadioDiscovery - Indicates that this station is operating in AP Discovery mode. In this mode, APs transmit and measure each other's beacons. APs measure signal strength as received from other APs, levels of RF interference experienced during transmission / reception and report back the same to the NM. siteSurveyTempSettings - Indicates that the station is operating in AP assisted site survey mode with temporary channel and transmit power settings applied to the dot11 interface identified by ifIndex. siteSurveyNonTempSettings - Indicates that station is operating in AP assisted site survey mode with it's original channel and transmit power with the temporary settings not applied to the dot11 interface identified by ifIndex.

Back to CISCO-DOT11-RADIO-DIAGNOSTIC-MIB MIB page.

IPHost Network monitor allows you to monitor cDot11RadioDiagMode on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of cDot11RadioDiagMode with IPHost tools

MIBs list