ciscoDlswTConnOperState - cisco Data Link Switching T Connection Operation State - CISCO-DLSW-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ciscoDlswTConnOperState

cisco Data Link Switching T Connection Operation State
1.3.6.1.4.1.9.10.9.1.2.3.1.6

The state of this transport connection. The transport connection enters `connecting' state when DLSw makes a connection request to the transport layer. Once initial Capabilities Exchange is sent, the transport connection enters enters `initCapExchange' state. When partner capabilities have been determined and the transport connection is ready for sending CanUReach (CUR) messages, it moves to the `connected' state. When DLSw is in the process of bringing down the connection, it is in the `disconnecting' state. When the transport layer indicates one of its connections is disconnected, the transport connection moves to the `disconnected' state. Whereas all of the values will be returned in response to a management protocol retrieval operation, only two values may be specified in a management protocol set operation: `quiescing' and `disconnecting'. Changing the value to `quiescing' prevents new circuits from being established, and will cause a transport disconnect when the last circuit on the connection goes away. Changing the value to `disconnecting' will force off all circuits immediately and bring the connection to `disconnected' state.

Back to CISCO-DLSW-MIB MIB page.

IPHost Network monitor allows you to monitor ciscoDlswTConnOperState on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of ciscoDlswTConnOperState with IPHost tools

MIBs list