cdsIfSrcGuardConfigTable - CISCO DHCP SNOOPING If Source Guard Config Table - CISCO-DHCP-SNOOPING-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

cdsIfSrcGuardConfigTable

CISCO DHCP SNOOPING If Source Guard Config Table
1.3.6.1.4.1.9.9.380.1.6.1

A table provides the mechanism to enable or disable IP Source Guard at each physical interface capable of this feature. Some of the interfaces (but not limited to) for which this feature might be applicable are: ifType = ethernetCsmacd(6). When DHCP Snooping is enabled at an interface, a list of IP addresses is obtained through DHCP Snooping for this particular interface. If IP Source Guard is enabled, only traffic from these IP addresses is allowed to pass through the interface.

Back to CISCO-DHCP-SNOOPING-MIB MIB page.

IPHost Network monitor allows you to monitor cdsIfSrcGuardConfigTable on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco wireless switches right now.

Easy monitoring of cdsIfSrcGuardConfigTable with IPHost tools

MIBs list