ccasIfExtVoiceCfgModemPassThru - Cisco CAS If Ext Voice Configuration Modem Pass Thru - CISCO-CAS-IF-EXT-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ccasIfExtVoiceCfgModemPassThru

Cisco CAS If Ext Voice Configuration Modem Pass Thru
1.3.6.1.4.1.9.9.314.1.1.1.1.6

This object specifies the modem pass-through mode: (1) passThruDisabled: Modem pass-through is disabled (2) passThruCisco: Cisco Proprietary PV (Protocol Violation) modem protocol used in modem pass-through. (3) passThruNse: Name Signaling Events(NSE) used in modem pass-through. (4) passThruNseAal2: Name Signaling Events(NSE) over AAL2 used in modem pass-through. (5) passThruCa: Gateway modem pass-through is based on Call Agent(CA) Control. (This is a special way used by SGCP) (6) passThruTypeE: FRF.11 Payload Type E packet used in modem pass-through. (7) system: System level modem pass-through configuration is used for the dial-peer. (8) passThruNseCa: Name Signaling Events(NSE) over IP modem pass-through controlled by gateway in MGCP 1.0 DEFVAL { passThruNse } ::= { ccasIfExtVoiceCfgEntry 6 } SYNTAX CvcCoderTypeRate MAX-ACCESS read-write STATUS current DESCRIPTION This object specifies the CODEC type to use for modem upspeed. Upspeed is to change the transmission rate of the voice interface to a higher rate of CODEC type.

Back to CISCO-CAS-IF-EXT-MIB MIB page.

IPHost Network monitor allows you to monitor ccasIfExtVoiceCfgModemPassThru on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco routers right now.

MIBs list