CISCO-CABLE-DIAG-MIB - ccdTdrIfResultPairStatus

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

ccdTdrIfResultPairStatus

Cisco Cable Diagnostic Tdr If Result Pair Status
1.3.6.1.4.1.9.9.390.1.2.2.1.8

The status of the cable pair. 'unknown' -- none of the following. 'terminated' -- the pair is properly terminated at the remote end. 'notCompleted' -- the test on this pair is not completed. 'notSupported' -- the test on this pair is not supported. 'open' -- the pair is open. 'shorted' -- the pair is shorted. 'impedanceMismatch' -- the impedance of the pair is mismatched. 'broken' -- the pair is broken. 'indeterminate' -- the status of the pair is indeterminate.

Back to CISCO-CABLE-DIAG-MIB MIB page.

IPHost Network monitor allows you to monitor ccdTdrIfResultPairStatus on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

MIBs list