Cisco ATM Trunk Cid Table

1.3.6.1.4.1.9.9.351.1.1.1

This table is used to establish the mapping of one or more DS0 channels from a single DS1 interface to an AAL2 connection identified by a Channel IDentification number(CID). This table is created and used for ATM AAL2 trunking applications including both voice and data. ::= { cAtmTrunkCidConfig 1 } SYNTAX CatmtCidEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION An entry in the catmtCidTable. Each entry represents an AAL2 trunking connection which is uniquely identified by the PVC index and the CID number. An AAL2 trunking connection is established by binding one or more DS0 channels from a single DS1 interface to an AAL2 ATM connection identified by the CID. The Channel IDentification (CID) is the standard term used to identify an ATM AAL2 connection (ITU-T I.366.2). CID is unique within a VC, either a PVC or SVC connection. INDEX { ifIndex, catmtCidVpi, catmtCidVci, catmtCid } ::= { catmtCidTable 1 } CatmtCidEntry ::= SEQUENCE { catmtCidVpi Unsigned32, catmtCidVci Unsigned32, catmtCid Integer32, catmtCidDs1 InterfaceIndex, catmtCidDs0GroupIndex Integer32, catmtCidProfileType CiscoAal2ProfileType, catmtCidProfileNumber CiscoAal2ProfileNumber, catmtCidVoiceCodec CvcSpeechCoderRate, catmtCidVBDCodec CvcCoderTypeRate, catmtCidNx64Enable TruthValue, catmtCidNx64Profile Integer32, catmtCidStateBitMap BITS, catmtCidRepetition ConfigIterator, catmtCidRepetitionOwner OwnerString, catmtCidRepetitionResult BulkConfigResult, catmtCidRowStatus RowStatus } SYNTAX Unsigned32 (0..4095) MAX-ACCESS not-accessible STATUS current DESCRIPTION This object is the VPI value of an ATM PVC connection. ::= { catmtCidEntry 1 } SYNTAX Unsigned32 (0..65535) MAX-ACCESS not-accessible STATUS current DESCRIPTION This object is the VCI value of an ATM PVC connection. ::= { catmtCidEntry 2 } SYNTAX Integer32 (8..255) MAX-ACCESS not-accessible STATUS current DESCRIPTION This object is the CID of an ATM AAL2 connection, it is unique within a PVC or SVC connection. The CID number at both sides of an AAL2 connection must be the same. Value of 0 is not used, and values of 1 to 7 are reserved for layer management by ITU-T I.366.2 standard. REFERENCE ITU-T recommendation I.366.2.