Cisco ATM Switching Fabric Vc Endpoint Table

1.3.6.1.4.1.9.9.112.1.2.1

This table contains information about Frame Relay end-points of FR-ATM interworking connections on the switch. When an entry is created in this table, the agent creates a corresponding entry in the atmVclTable of ATM-MIB, to represent the configuration on the internal ATM port. The mapping between an entry in this table, and the corresponding entry in the atmVclTable is shown in the casfFAMapTable and the casfAFMapTable. Entries can be created or deleted in this table by an NMS using the casfVcEndptRowStatus object. To create a PVC connection end-point, the value of casfVcEndptConnKind must be 'pvc'. To create a soft VC initiator end-point, set the value of casfVcEndptConnKind to 'spvcInitiator', and specify the value of casfVcEndptSpvcRemoteAddr and casfVcEndptSpvcRemoteType. If the value of casfVcEndptSpvcRemoteType is 'frameRelay', you must also specify the value of casfVcEndptSpvcRemoteDlci. Activating the conceptual row will then cause the agent to attempt to establish a connection to the remote frame relay interface. If the value of casfVcEndptSpvcRemoteType is 'atm', you must specify the values of casfVcEndptSpvcRemoteVpi and casfVcEndptSpvcRemoteVci. Activating the conceptual row will then cause the agent to attempt to establish a connection to the remote ATM interface. The agent creates an entry in this table when an incoming signaling request causes a soft VC connection to be established with a local frame relay interface as the destination. The value of casfVcEndptConnKind in this case will be 'spvcTarget'. Such entries cannot be modified or deleted by network management. They will be deleted when the connection is removed by signaling.