csfFilterEntry - Cisco ATM Signaling Failures Filter Entry - CISCO-ATM-SIG-DIAG-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

csfFilterEntry

Cisco ATM Signaling Failures Filter Entry
1.3.6.1.4.1.9.9.78.1.2.1.1

Each entry in this table corresponds to a filtering criteria based on which the rejected calls are recorded. This selection criteria is applied against all connection setup failures generated/detected at this ATM device. Only connection setup failures which match against all of the entry's criteria are recorded in the csfRecordTable. A new entry can be created by specifying a csfFilterIndex value that is currently not being used and also using an appropriate value (createAndGo or createAndWait) for the csfFilterRowStatus object. If a particular call failure matches multiple entries in the csfRecordTable then multiple entries will be created in the csfRecordTable for each of the matched entries in the csfFilterTable . An entry in the csfFilterTable could also be created via the command line interface, available on the ATM devices.

Back to CISCO-ATM-SIG-DIAG-MIB MIB page.

IPHost Network monitor allows you to monitor csfFilterEntry on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.

Easy monitoring of csfFilterEntry with IPHost tools

MIBs list