rtsIfBeCfgRequested - rts If Be Configuration Requested - CISCO-ATM-RM-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

rtsIfBeCfgRequested

rts If Be Configuration Requested
1.3.6.1.4.1.9.10.10.1.10.1.1.5

This object reflects the traffic shaping configuration applied to Best-Effort Connections(VC or VP) belonging to UBR and ABR service categories on this interface. If this object is set to the value 'shapingDisable', best-effort connections(VC or VP) on this interface will not be shaped. If this object is set to the value 'shapeToPcr', the best-effort connections(VC or VP) on this interface will be shaped to conform to their respective PCR traffic parameter. Depending on the capabilities of the traffic shaping hardware, the changes to the traffic shaping configuration may or may not take effect immediately and may require that the traffic shaping hardware be reset to effect the change. The object rtsIfBeCfgInstalled will reflect the actual best-effort Traffic Shaping configuration installed in the hardware currently. Depending on the capabilities of the traffic shaping hardware, the value of this object may or may not apply to terminating best-effort VPs on this interface. This object is not instantiated for interfaces to which it cannot be applied.

Back to CISCO-ATM-RM-MIB MIB page.

IPHost Network monitor allows you to monitor rtsIfBeCfgRequested on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

Easy monitoring of rtsIfBeCfgRequested with IPHost tools

MIBs list